Wingbits
Wingbits - English
Wingbits - English
  • Introduction
    • What is Wingbits?
    • Who can use Wingbits Data?
    • Terminology
    • For the DePin Crew
    • Official Wingbits Channels
    • Our Plan
    • How to get involved
  • rewards
    • How to maximize rewards
  • Get Started
    • Hardware needed
      • HYFIX Hardware Setup
      • Wingbits Onboarding
      • HYFIX Hardware FAQ
    • How to claim your station location
    • Add wallet address to your account
    • Enable devnet on wallet apps
      • Phantom
      • Solflare
    • Monitor with Grafana cloud
  • Site Info
    • Change Password
  • BYOD (DIY) Station Info
    • BYOD Stations
      • Hardware needed
      • Hardware suggestions
      • GeoSigner FAQ
      • Setup steps guide
      • Installing new client
      • Install GeoSigner
      • Debug your station
      • Install wb-config tool
      • Theoretical range of coverage
  • Project
    • Wingbits Litepaper
    • Wingbits Roadmap
    • Wingbits FAQ
    • Distributors of approved hardware
    • Wingbits Approved Hardware Program
Powered by GitBook
On this page
  1. Get Started
  2. Enable devnet on wallet apps

Solflare

Step by step to enable devnet on your Solflare Wallet app

PreviousPhantomNextMonitor with Grafana cloud

Last updated 7 months ago

Solflare does not properly support devnet cluster on Solana. While this is a valid wallet app to use once we move to Mainnet, it really has no use during the current devnet phase. wallet app seems to be the only mobile app that correctly supports devnet cluster (although transactions aren't visible on it either, only test token balances)

Step 1: Download & Open Solflare Wallet. When you set it up, dont forget to save your recovery phrase in a secure location.

Step 2: The first screen when you have opened the Phantom wallet should look something like this. Go ahead and click the settings button in the bottom right corner to open the settings tab. See step 3.

Step 3: Now you should see the settings tab opened like the picture below. Click General and then see step 4.

Step 4: After clicking General, you should see this screen seen below. Go ahead and click Network. After you have done that, see step 5.

Step 5: After clicking network, you will see this screen. Click and enable Devnet, then see step 6

Step 6: When you click to enable Devnet, you will automatically be taken back to the home screen. Now the setups is complete. Just make sure you add the public address to your antenna/station page. For that,

see the how to guide.
Phantom